Torqeedo Cruise 2.0 FP Originalbetriebsanleitung Seite 102

DE EN
Display
E78
E79
E80
E81
E82
E83
E84
E85
For any error which is not listed, and for any error which cannot be corrected through the measures described above, contact Torqeedo Service or an authorised Service Part-
ner.
page 102 / 120
Cause
Overcharging of battery
Battery has electronics defect
Deep discharging
Water sensor is triggered
Differing state of charge of multiple batteries
Software version error for battery
Number of batteries does not agree with the enu-
meration
Imbalance of a battery
What to do
Remove charger unit (use only Torqeedo charger unit).
Switch battery on and off.
Contact Torqeedo Service.
Contact Torqeedo Service.
Ensure that the battery's environment is dry; if necessary clean the battery
and water sensor.
Switch battery on and off.
Remove the wiring of the battery bank, and fully charge each battery indi-
vidually.
Batteries with different software versions have been connected together.
Contact Torqeedo Service.
Check the connections of the batteries (expected number of batteries is
shown on the display, below the error code).
If necessary, repeat enumeration or check functioning of batteries individ-
ually, see Chapter 5.7.2, "Start-up the on-board computer with battery
Power 26-104"
During the next charging process, do not disconnect the charger unit after
the battery is fully charged.
After the end of the charging process, leave the charger unit connected for
at least 24 hours longer.
Error messages