Safety Instructions For Maintenance And Care - ergoline Prestige Series Gebrauchsanweisung

Safety instructions for maintenance and care

Danger to life!
Disconnect the sunbed from the power supply when performing
maintenance work requiring opening of the device.
See Page 204.
Maintenance and care play a major role in deciding whether your sunbed
meets your requirements satisfactorily. Compliance with the specified
maintenance intervals and thorough maintenance and care are therefore
absolutely essential.
You can call up the current operating hours of the parts to be serviced in
preset mode.
Refit any protective devices (e.g. filter panels) after finishing working on
the sunbed.
Please note that the device must be inspected regularly by our customer
service or an approved specialised company every 12 months (from date
of commissioning) to maintain its proper condition.
Note!
In these devices, the lamp output is regulated electronically.
Therefore, replace the entire set of UV low-pressure lamps after
the specified operating time. The new UV low-pressure lamps
are not operable until the corresponding chip card is inserted
(see Page 218).
Caution!
Use only genuine spare parts of the same type! The use of
other parts voids the CE conformity!
Any liability is excluded in the case of damage or injury proven
to be the result of the use of non-genuine spare parts.
Fire hazard!
High-pressure lamps that have not been approved by Ergoline
can explode. Hot lamp components can set other components
on fire. People can be killed or severely injured due to smoke
inhalation and fire.
– Only fit high-pressure lamps recommended by Ergoline.
– Clean the inside of the tanning device regularly. Dust-
particles are combustible!
203