Decalcifying The Water Reservoir - Melitta CAFFEO Bedienungsanleitung

→
The symbol for the valve
and into the vessel. Subsequently the symbol for the valve
nated.
15 Turn the valve switch anticlockwise to close the valve.
→
Water flows inside the appliance into the drip tray. Subsequently, the symbol
for the drip tray
16 Empty the drip tray and the coffee grounds container.
17 Wait until the steam pipe cools down and slide the whisk onto the steam
pipe, from below, until it locks in place.
18 Reinsert the drip tray with the coffee grounds container.
→
The on/off button
The buttons and the bean symbols
The appliance is ready for operation.

Decalcifying the water reservoir

You should decalcify the water reservoir regularly to ensure faultless function.
• Flip up the lid of the water reservoir (Fig. A, no. 3) and pull the water
reservoir up and out of the appliance.
• Remove the Claris
page 49).
• Fill the water tank with an off-the-shelf decalcifier. We recommend using
the liquid quick decalcifier from Swirl
vided by the manufacturer of the decalcifier.
•
Then thoroughly rinse the water reservoir with clean water.
• Replace the Claris
page 49).
• Fill the water reservoir with fresh water and reinsert it into the appliance.
is flashing. Water flows out of the steam pipe
will be illuminated.
will be illuminated after a brief heat-up phase.
water filter - if present - from the water reservoir (see
®
water filter - if present - in the water reservoir (see
®
are illuminated.
. Comply with the instructions pro-
®
will be illumi-
69