Filling The Water Reservoir; Switching On And Venting - Melitta CAFFEO SOLO & milk Bedienungsanleitung

Filling the water reservoir

• Flip up the lid of the water reservoir (Fig.
reservoir up and out of the appliance.
•
Fill the water reservoir with fresh water to the Max. mark and re-insert it
in the appliance.
Note
If the water reservoir runs empty during operation (e.g. during the coffee
dispensing process), the symbol for the water reservoir will be illuminated.
the current operation will be stopped and the water reservoir must be
filled before starting a new operation.

Switching on and venting

All lines in the appliance have been drained and vented in the factory. consequently,
the first time the appliance is switched on the valve symbol
after the heat-up phase and the appliance must be vented via the valve. Venting is only
necessary the first time that the appliance is started up.
Caution!
the appliance may only be vented without the claris
with a full water reservoir.
– Insert the Melitta
ing.
–
Fill the water reservoir with fresh water to the Max. mark
ing.
•
Press the On/Off button
→
the standby symbol
After heating up the symbol for the valve will be illuminated
•
Place a large vessel under the steam pipe.
• turn the valve switch (Fig.
→
the valve symbol
steam pipe.
claris water filter into the appliance only after vent-
® ®
to switch the appliance on.
will flash. The appliance will heat up.
A, no. 11) clockwise to open the valve.
will flash. Water will flow into the vessel under the
A, no. 7) and pull the water
will be illuminated
water filter and
®
before vent-
.
53