Troubleshooting - Clatronic KA-V 3002 Bedienungsanleitung

Fault
The machine does No power supply
not turn on when the
mains switch is
operated
Service door is open
The brewing Coffee dregs box not correctly
process does not inserted
start
Water tank is empty
Machine is in steam mode
Brew unit not inserted correctly
When grinding, the Coffee beans have been used up
grinding gear noise
gets louder
There is no Nozzle is blocked
steam/hot water
coming from the
steam nozzle
Very little or no Coffee outlet is blocked
coffee comes out
Water cycle is blocked by scaling
Grinding level for coffee is too fine
Brew unit not inserted correctly
The warm-up time is Machine is scaled
longer
The coffee is not Wrong coffee mixture
frothy
Grinding level for coffee is too coarse Choose a finer grinding level
The milk is not Milk is unsuitable
foamed up or foams
up only a little
The brew unit is Starting position for the brew unit
stuck in the service does not agree with the starting
compartment position of the drive shaft

Troubleshooting

Before sending the machine to the Customer Services, use the
following table to check whether you can rectify the fault yourself.
WARNING:
Before troubleshooting, turn the machine off and remove the
mains plug. Wait until the machine and accessories have cooled
down. Never use a defective machine.
Possible cause Solution
Put the mains plug in correctly, if necessary,
check the socket is working with another
machine.
Close the service door (Fig. 1/6).
Insert the coffee dregs box correctly
"Cleaning/emptying the coffee dregs box".
Fill up the water tank Page 41, "Filling the water
tank".
Switch the machine back to normal mode
44, "Foaming up milk".
Reinsert the brew unit correctly
"Cleaning the brew unit".
Fill up the coffee bean container
"Filling with coffee".
Clean the steam nozzle
hot water/steam nozzle".
Clean the coffee outlet and the filter
"Cleaning and maintenance".
Descale the machine Page 50, "Descaling"
Choose a coarser grinding level
"Setting the grinding level".
Reinsert the brew unit correctly
"Cleaning the brew unit".
Descale the machine Page 50, "Descaling"
Use another coffee mixture
the grinding level".
Choose low-fat milk.
Release the brew unit Page 55, "Releasing the
brew unit".
Troubleshooting
Chapter ,
Page
Page 54,
Page 41,
Page 58, "Cleaning the
Page 52,
Page 52,
Page 54,
Page 52, "Setting
59