Removing And Refitting The Door Panels - Junker JB11AB.0 Serie Gebrauchsanleitung

Attaching the door
Reattach the oven door in the reverse sequence to removal.
When attaching the oven door, ensure that both hinges are
1.
inserted straight into the opening (figure A).
The notch on the hinge must engage on both sides (figure B).
2.
Fold back both locking levers (figure C). Close the oven
3.
door.
:
Risk of injury!
Risk of injury. If the oven door falls out accidentally or a hinge
snaps shut, do not reach into the hinge. Call the after­sales
service.

Removing and refitting the door panels

The glass panels can be removed from the oven door to allow
more thorough cleaning.
Removal
Removing the oven door See the section Removing the oven
1.
door. Lay the oven door on a cloth with the handle facing
downwards (Fig. A).
First turn the two screws at the bottom anticlockwise, then the
2.
two screws at the top, also anticlockwise (Fig. B).
38
Remove the cover (Fig. C).
3.
The parts that have been removed must not be washed. Clean
the panels with a glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Refitting
Place the cover back in position (Fig. A).
1.
First retighten the two screws at the bottom, then the two
2.
screws at the top (Fig. B).
Fitting the oven door See the section Fitting the oven door.
3.
Do not use the oven again until the panels have been
correctly fitted.