Scope Of Delivery; Special Features Of The Da 6000 Digital Display; Technical Data - impac DA 6000 Handbuch

English manual
Congratulations on choosing the high quality and highly efficient IMPAC digital display.
Please read this manual carefully before installing this pyrometer. It contains all the necessary information to
set up and operate the new IMPAC pyrometer.
Should you require further assistance, please call our customer service hotline
in Germany +49 (0)69 9 73 73-190.
1.

Scope of delivery

− DA 6000 digital display with screw clips and PC software InfraWin
2.

Special features of the DA 6000 digital display

− Interface connection (selectable for RS232 or RS485) for communication with digital pyrometers or
for connection to a PC
− Analog connection selectable for either 0 - 20 mA or 4 - 20 mA
− Power supply requirement of either 85 - 265 V AC or 18 - 30 V DC
− Two alarm output levels (relays)
− Switchable 5 V DC output voltage (max. 50 mA) for an LED pilot or aiming light (at IGA 300, IS 300)
− Maximum value storage with auxiliary input for external reset
− Program set-up parameters of digital pyrometers
− Integrated power supply for two-wire pyrometers
Please be sure that the mains cable connections are sufficiently
3.

Technical data

Temperature display:
Operating mode indication: 4-digit LED matrix, 5 mm, red
Measurement range:
Power supply:
(galvanically separated)
Power consumption:
Analog input:
(galvanically separated); only
in operating mode [aMes]
Analog output:
(galvanically separated)
Digital interface:
(galvanically separated)
Alarm outputs:
Pilot light output:
Reset input:
Safety note:
protected from contact!
7 segment LED, 13 mm, red
-100.0 to 3200 °C (-148.0 to 5792 °F)
85 to 265 V AC, 48 to 62 Hz
or: 18 to 30 V DC, ripple max 0.5 V
approx. 7 VA (without external devices connected)
0 or 4 - 20 mA output (selectable), input resistance: 10 Ω
Auxiliary power supply for two-wire pyrometers: 24 V
0/4 - 20 mA output, active, max. load 500 Ω, within the measurement range,
restriction as a partial measurement range can be chosen freely
Either RS232 or RS485 half duplex, addressable,
Baud rate 1.2 - 38.4 kBd
For communication with a digital pyrometer
2 relay outputs (switchable), 6 A, 400 V AC, 300 V DC, max. 1500 W.
optionally semiconductor relays: 3 A, 60 V AC/DC (upon request)
Switchable 5 V DC output voltage, max. 50 mA
I I
(for S 300 or GA 300 pilot lights)
To reset the stored Maximum Value with an external signal
(TTL level or external contact)
[dMes] or a computer [aMes]
20