grabner holiday Eignerhandbuch Seite 27

► ►
Slide the deflated outrigger floater (25)
with the back loop, from the back on the
long part of the outrigger sheet, until it
reaches the tube – the valve on the floa-
ter is at the front.
► ►
Slide the back loop on the short part of
the outrigger sheet until it reaches the
tube.
► ►
Pull the back loop back again and inflate
the outrigger floaters to operating pres-
sure (0,3 bar).
► ►
Assemble the steering device (not sup-
plied) on your boat.
dISMANTLING
► ►
Remove the boom lowerer – which re-
mains tied to the sail.
► ►
Unthread the main sheet and remove the
main sheet block.
► ►
Put down the whole mainsail and remove
the main halyard completely.
► ►
Pull out the jib sheet from the clamps and
guiding eyes – leave the jib sheet tied to
the sail.
► ►
Hold the mast well and release the belt
of the foresail from the bow of your boat.
► ►
Unhook the shroud ropes.
► ►
Lift the mast and bring it down.
► ►
Remove the shroud ropes, the foresail
and the pennant from the mast.
► ►
Separate the mast parts by pressing on
the spring latch bolt and pulling them
apart.
► ►
Deflate the outrigger floaters and remove
them from the outrigger.
► ►
Remove the outriggers by pressing on
the spring latch bolt and pulling them out.
► ►
Deflate the boat.
► ►
Unscrew the crossbridge.
► ►
HOLIDAY: unscrew the cross brace and
the fixing tubes from the backrest fittings.
► ►
EXPLORER: remove the fixing tubes.
► ►
RIVERSTAR: unscrew the fixing tubes.
► ►
To avoid losing the knurled nuts, apply
them on the screws again.
► ►
Pack the sails in your packing bag (not
supplied).
27