Changing The Ringtone Of The Doorbell; Changing The Floor Ringtone; Light And Special Function Key; Technical Data - sks HT4500 Installationsaleitung

SKS-Kinkel Elektronik GmbH
HT4500

Changing the ringtone of the doorbell

5.7
Keep the tone key pressed for some time to change the ringtone of the doorbell. At the same time
briefly tap on the door open key within 1.5 seconds. This key combination will change the ringtone
of the doorbell. Every time you tap on the door open key another ringtone will be played. To select
+
the respective ringtone release both buttons. The selected ringtone will then be the default setting.
Note
There is a choice of 8 ringtones for the house call and 4 ringtones for the floor call. The ringtone for
the house call signals that the intercom has been activated at the door bell/station at the front door
outside. The floor ringtone signals that the intercom has been activated at the door bell/station
located on the floor inside the building.

Changing the floor ringtone

5.8
To change the ringtone for the floor bell, keep the tone key pressed for some time. Within 1.5
seconds, and in addition to pressing the tone-image-key, it is necessary to keep the door open
+ key pressed for the same amount of time in order to change the ringtone for the floor bell. If both
keys are kept activated, another ringtone will be played. To select this ringtone release both keys.
The selected ringtone will then be the default setting.
Note
There is a choice of 8 ringtones for the house call and 4 ringtones for the floor call. The ringtone for
the house call signals that the intercom has been activated at the door bell/station at the front door
outside. The floor ringtone signals that the intercom has been activated at the door bell/station
located on the floor inside the building.

Light and special function key

5.9
Two keys may be used for special functions. In this way, it is possible to have a variety of switch
functions using the S and light key in combination with a bus actuator module or a switch actuator.
Press the selected key until an acoustic signal confirms that the function has been executed.
Note
Please note that the function „ Light and special function key " is only available for the special version
of the indoor station.
6

Technical data

Electric data
Voltage a+ / b-
General
Ambient Temperature
Humidity
Housing
Dimensions (width x height x depth)
Type
Support-Hotline: +49 (0) 2661 98088 112
E-Mail: support@sks-kinkel.de
19 – 23 VDC
-10°C to +45°C
20% to 90% not condensing
Plastichousing
89 x 230 x 58 mm
IP20
- 22 -
EN
Version: 2.1
Document art. no. 97005802