Specifications; Standard Accessories - Hitachi DH 45MR Bedienungsanleitung

PRECAUTIONS ON USING ROTARY HAMMER
1. Wear ear protections
Exposure to noise can cause hearing loss.
2. Do not touch the bit during or immediately after
operation. The bit becomes very hot during
operation and could cause serious burns.
3. Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.

SPECIFICATIONS

Voltage (by areas)*
Power input
Capacity
No load speed
Full-load impact rate
Weight (without cord, side handle)
*Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case ............................................................................. 1
(2) Side Handle ................................................................ 1
(3) Stopper ........................................................................ 1
(4) Hexagon Bar Wrench (for 6 mm screw) ............. 1
(5) Hexagon Bar Wrench (for 5 mm screw) ............. 1
(6) Hammer Grease A .................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Through-hole drilling (Rotation + Hammering)
(1) Drill bit (SDS max shank)
Outer diameter (mm)
16
19
22
25
28
32
38
40
Overall length (mm)
340, 540
320, 520
370, 570
4. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
5. Always hold the body handle and side handle of
the power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
6. Wear a dust mask
Do not inhale the harmful dusts generated in
drilling or chiseling operation. The dust can
endanger the health of yourself and bystanders.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
1200 W*
Drill bit: 45 mm
Core bit: 125 mm
120 – 240 min
1250 – 2500 min
8.0 kg
2. Anchor hole drilling (Rotation + Hammering)
Drill bit (Taper shank)
(1) Drill bit (taper shank)
External dia.: 11, 12.3, 12.7,
14.3, 14.5,
17.5 mm
Taper shank
Application drill bit
adapter
Morse taper Drill bit (taper shank)
(No. 1) 11, 12.3, 12.7, 14.3, 14.5, 17.5 mm
Adapter for SDS-plus shank bit
(1) Drill bit
(SDS-plus shank)
3. Large dia. hole boring (Rotation + Hammering)
(Guide
(1) Center
plate)
pin
(1) Center pin
Applied to core bits from 38 mm to 125 mm
Applied to core bits 32 mm and 35 mm
English
-1
-1
(3) Cotter
(2) Taper shank
adapter
(SDS max shank)
(2) Adapter for SDS-plus
shank bit
(SDS max shank)
(2) Core (3) Core bit shank
bit (SDS max
shank)
6