Bosch MCM 3 Series Gebrauchsanleitung Seite 17

Attach lid with pusher (match arrow on lid

to arrow on bowl) and rotate in a clock-
wise direction. Lid lug must be located
fully in the slot in the bowl handle.
Insert the mains plug.

Set the rotary switch to the desired

setting.
Fill with contents which are to be sliced

or shredded.
When adding contents which are to

be sliced or shredded, apply only light
pressure to the pusher. Remove the
pusher and add ingredients through
the feed tube.
Warning!
Empty the bowl before it becomes so full
that the cutting or grating contents reach
the carrier disc.
After using the appliance
Set the rotary switch to 0/off.

Remove mains plug.

Rotate the lid in an anti-clockwise

direction and remove.
Remove tool:

– Take tool holder together with
universal blade, whisking disc or
kneading hook out of the bowl.
Remove the tools from the tool holder.
– Take out the cutting discs by the
plastic stud in the centre. Take tool
holder out of the bowl.
Rotate bowl anti-clockwise and remove.

Clean all parts, see "Cleaning and

servicing".
Blender
Blade insert with blender/cutting blade for
mixing liquid or semi-solid food, for cutting/
chopping raw fruit and vegetables, for
puréeing food.
m
Risk of injury from sharp blades/
rotating drive!
Never place fingers in the attached
blender!
Do not remove/attach the blender until the
drive is at a standstill.
Do not touch blades of the blade insert
with bare hands. Clean them with a brush.
Robert Bosch Hausgeräte GmbH
m
Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid. Add a max.
0,4 litres of hot or frothing liquid.
Warning!
Blender may be damaged. Do not process
deep-frozen ingredients (except ice cubes).
Do not operate blender when empty.
Fig. 
Place seal on the blade insert. Ensure

that the seal is positioned correctly.
Important information
If the seal is damaged or not correctly
positioned, liquid may run out.
Insert blade insert with blender/cutting

blade into the blender jug and lock
anti-clockwise ( ).
Turn blender jug over (blade insert face

down).
Attach the blender jug (match arrow on

the jug to the arrow on the appliance) and
rotate as far as possible in a clockwise
direction.
Add ingredients.

Maximum capacity, liquid = 1.0 litres
(frothing or hot liquids max. 0.4 litres).
Optimal processing capacity – solids =
80 g.
Attach lid and press firmly.

Hold lid while working.
Insert the mains plug.

Set the rotary switch to the desired

setting.
To add more ingredients, set the rotary

switch to 0/off.
Remove the lid and add ingredients

or
remove the funnel and gradually add solid

ingredients through the refill opening
or
pour liquid ingredients through the funnel.

After using the appliance
Set the rotary switch to 0/off.

Remove mains plug.

Rotate the blender in an anti-clockwise

direction and remove.
Remove lid.

en
17
17