Resetting The Defaults - G&D DVIMUX2-DL-PS/2 Installationanleitung Und Betriebsanleitung

Configuration

Resetting the defaults

This function resets the default settings of the KVM switch.
IMPORTANT:
Performing this function reactivates the default settings of the KVM
switch as shown on page 12.
How to reset the default settings:
1. Press Hotkey+Backspace
the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press the setup key listed below to reset the default settings:
 reset default settings
D
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Switch mode of the service port is
enabled. Enter »
2. Use the
Arrow
3. Press
Enter
4. Confirm the pop up security query with
Pressing the
21 · G&D DVIMUX2-DL-PS/2
(default:
« to switch to the setup menu.
#!
or keys to select the
Arrow
to reset the default settings.
key cancels the function.
Q
Ctrl+Backspace ) simultaneously to enable
Set System Defaults
Enter .
entry.