Charging The Rechargeable Battery; Before Using The Device For The First Time; In Daily Use - Meister AS108VM Originalbetriebsanleitung

5401030-Akku-Bohrs-man 18.02.14 09:30 Seite 49
Power consumption
Output voltage
Capacity
Protection class
Protection class
5 – Charging the
rechargeable battery
Before using the device for the first
time
The battery is not completely
charged when the item
leaves the factory.
Figure 5-1: Connect the plug power
supply and the charger cradle. Insert the
rechargeable battery as far as it will go
into the battery compartment.
The LEDs on the battery indicate the
charging process:
LED LED
Red Yellow Green
The charging process takes about
3 to 5 hours.
Remove the rechargeable battery from
the charger cradle after you have
finished charging it.
The rechargeable battery will
attain its full performance
12 W
12 V – ...
400 mA
II (dual
insulation)
IP X0
LED Charging
process
Initial
Advanced
Complete
capability only after a number of
charging cycles.
Figure 5-3: Insert the rechargeable
battery as far as it will go into the
handle of the cordless drill-screwdriver.
The cordless drill-screwdriver is ready
for operation.

In daily use

In order to protect the
rechargeable battery:
Recharge the battery before
it is completely discharged.
Figure 5-2: Check the battery charge
state:
LED LED LED
Red Yellow Green
Figure 5-4: Take the rechargeable
battery out of the handle of the cordless
drill-screwdriver.
Figure 5-1: Charge the rechargeable
battery.
Figure 5-3: When the rechargeable
battery has been charged, insert as far
as it will go into the handle of the
cordless drill-screwdriver.
The cordless drill-screwdriver is ready
for operation.
Charge state
Almost empty
Half-full
Full
49