Intended Use; Requirements For The Place Of Operation; Electrical Connection - Beem Odessa Original Bedienungsanleitung

_______________________________________________________________
14 EN

Intended use

This appliance is only used for heating water
for tea and hot instant drinks for industrial or
household use.
Any use other than previously stated is con-
sidered as improper use.
WARNING
If not used for its intended purpose and/or
used in any other way, the appliance may
be or become a source of danger.
► Use the appliance only for its intended
purpose.
► Observe the procedures described in
this user manual.
No claims of any kind will be accepted for
damage resulting from use of the appliance
for other than its intended purpose.
The risk must be borne solely by the user.
Requirements for the place of
operation
For safe and trouble-free operation of the ap-
pliance, the installation location must satisfy
the following requirements:
Place the appliance on a horizontal, sta-
‹
ble, level, heat resistant surface that is also
resistant to splashing water.
The surface finishes on furniture may
‹
contain substances that can be detrimental to
the feet of the appliance. If necessary, place
a mat under the feet of the appliance.
Do not place the appliance in a hot, wet
‹
or very humid environment or in the vicinity of
inflammable materials.
Never place the appliance or parts of
‹
the appliance in the vicinity of strong heat
sources and hot surfaces (e.g., heating,
oven, grill).
When operating, do not leave any valu-
‹
able objects sensitive to moisture or heat in
the vicinity of the appliance in order to avoid
damage by hot steam and water.
Do not install the appliance under a wall
‹
cabinet.
Select a location that does not allow chil-
‹
dren to reach the hot surfaces of the appliance.
BEEM - Elements of Lifestyle
The mains socket must be easily accessi-
‹
ble and allow fast disconnection in the event
of an emergency.
Do not lay tablecloths, cloths or serviettes
‹
under the feet of the appliance, the appliance
could slide away.
The appliance may not be used or stored
‹
outdoors.

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on the
electrical connection must be observed:
Before connecting the appliance, com-
‹
pare the connection data (voltage and
frequency) on the rating plate with those of
your mains power supply. This data must
correspond in order to avoid damage to the
appliance. If in doubt, ask your electrical ap-
pliance retailer.
The mains socket must be protected by at
‹
least a 16 A fuse.
Ensure that the mains cable is undam-
‹
aged and is not laid over sharp edges.
The mains cable must not be pulled
‹
tightly, bent or come into contact with hot
surfaces.
Route the mains cable to prevent risk of
‹
tripping.
Always unwind the mains lead completely
‹
before connecting the appliance to the plug
socket.
The electrical safety of the appliance is
‹
only assured when it is connected to a prop-
erly installed protective earth (PE) conductor
system. Connection to a mains socket with-
out PE conductor is forbidden. If in doubt, the
electrical system must be checked by a quali-
fied electrician. The manufacturer assumes
no liability for injury or damage caused by a
missing or interrupted protective earth con-
ductor.