Before First Using This Appliance; How To Use This Appliance - Beem Pyramid A4 Bedienungsanleitung

29. Do not place the utensil on a base with a surface which is sensitive to water.
Splashing water could cause damage.
30. Never place the appliance near a gas flame, electric hotplate or other source of
heat. External heat can damage the appliance.
31. The utensil is equipped with a safety device which switches off the heater in
case of overheating or an empty tank. To avoid deactivating this device
accidentally, the utensil may not be operated with a timer or a similar device.
5.

Before first using this appliance

• Ensure that all packaging material has been removed from the appliance (protective
film, etc.).
• Under no circumstances remove the rating label or any warning labels.
CAUTION: check that the appliance is not damaged. If any parts are damaged,
do not use the appliance and contact a qualified service engineer.
• Do not place the appliance beneath an overhanging cupboard.
• Clean the appliance and the accessories before using it for the first time. This will
remove any debris that might remain from the production process.
6.

How to use this appliance

• Pour the required amount of fresh water. Do not fill past the max. filling level marking.
• Place steam cover and teapot onto the base unit.
• Ensure that the adjusting knob is turned anticlockwise until it reaches its detent.
• Then insert the plug into the mains socket.
• Turn the adjusting knob clockwise to its detent. The thermostat allows stepless
adjustment of the degree of heat. You can choose between the settings: boil /
interval boil / hot / warm.
• If you turn the adjusting knob to the detent, the water will boil rapidly. If you leave
the adjusting knob in this position, the water will boil continuously until it eventually
all evaporates. To prevent this uninterrupted boiling function, turn the adjusting knob
back until the blue signal light on the base unit goes out.
• Now the thermostat only switches on again when the temperature of the water drops,
heating it again. In this way, the thermostat regulates energy supply in accordance
with requirements, saving a great deal of energy. The blue signal lamp switches on
and off in the thermostat cycle.
Guideline values:
- Boiling water:
- Interval boiling:
- Hot water:
- Warm water:
BEEM – Elements of Lifestyle
Adjusting knob turned to the detent; water
temperature approx. 100°C
Maximum 1/8 turn back - as soon as the water has
boiled; water temperature approx. 95°C – 100°C
Adjusting knob turned back by about 1/4; water
temperature approx. 85°C – 95°C
Adjusting knob turned back by about 1/2; water
temperature approx. 60°C – 70°C
Seite/Page/Page/página 18 / 88