Makita 6904VH Betriebsanleitung Seite 5

For 6905H
– Standard bolt –
– High tensile bolt –
Hold the machine firmly and place the socket over the bolt or nut. Turn the machine on and fasten for the proper
fastening time.
NOTE:
• Hold the machine pointed straight at the bolt or nut without applying excessive pressure on the machine.
• Excessive fastening torque may damage the bolt or nut. Before starting your job, always perform a test
operation to verify the adequate fastening speed and time for your bolt or nut.
The fastening torque is affected by a wide variety of factors including the following. After fastening, always
check the torque with a torque wrench.
1. Voltage
Voltage drop will cause a reduction in the fastening torque.
2. Socket
• Failure to use the correct size socket will cause a reduction in the fastening torque.
• A worn socket (wear on the hex end or square end) will cause a reduction in the fastening torque.
Fastening time
Fastening time
Proper fastening torque for M20
Proper fastening torque for M16
Proper fastening torque for M12
Seconds
Proper fastening torque for M16
Proper fastening torque for M12
Seconds
5