KM39AA_100724_KM39AA_100724 02.08.10 09:30 Seite 19
ted, it will not be possible to turn the con-
trol knob to .
5. Press the start/stop button (9).
During start-up the appliance will auto-
matically determine the number of rin-
sing cycles required. If several rinsing
cycles are necessary, each cycle is in-
terrupted after 45 seconds and the
ready to brew indicator
green again. If this happens, press the
start/stop button (9). again. Since
there is already water in the appliance,
more water may come out the second
time, so put two empty cups underne-
ath the outlet.
Once rinsing is over, the low water in-
dicator
(10) will light up red and the
water will be heated. Turn the control
knob (7) back to the home position
Do not interrupt the rinsing cycles. Do
not remove the water container (5) and do
not pull out the power plug; otherwise
you will need to restart the start-up pro-
cess.
Coffee
Coffee soft pads
You can use all conventional coffee soft
pads with an outer diameter of 7 cm (cof-
fee quantity of approx. 7 g). Coffee pads
with a smaller diameter do not deliver the
best coffee. Hard pads offered for es-
presso machines and pads with additives
for cappuccino and such cannot be used.
Never fill damaged pads, loose coffee
powder or instant coffee into the pad car-
tridge (4), as it will clog and block the
control knob (7) so that the pad cartridge
(4) can no longer be removed. Should this
nevertheless happen, please read the in-
structions in the section "Help with pro-
blems."
Pad cartridge
The pad cartridge (4) can be used from
both sides. The side marked with is in-
tended for one coffee pad and the side
marked with is for two coffee pads.
The more carefully you insert the coffee
pads, the better the coffee will be. There-
fore we recommend that you adhere to
(11) flashes
the following instructions:
• Before inserting the coffee pad, distri-
bute the powder in the pad evenly up to
the edge.
• When using 2 coffee pads, press the
bottom pad tightly into the recess in the
pad cartridge (4), causing its paper
edge to fold upwards.
• Insert the top coffee pad and tap it
lightly into place with your finger tips so
that a small indentation develops in its
.
centre.
• Ensure that the paper edge of the top
coffee pad lies flat in the recess of the
pad cartridge (4) without projecting out-
wards or folding inwards.
• When pushing the pad cartridge (4) into
the appliance, make sure that the pad
does not shift, otherwise the seal will
not work reliably.
• Turn the control knob (7) in the
right as it will go.
djusting the coffee quantity
The quantity of coffee powder in a pad is
optimised for one cup of 125 ml. You can
change the strength of the coffee by vary-
ing the filling quantity per cup according
to your personal taste and requirements.
Depending on whether you're making one
or two cups, and how strong you like
your coffee, set the fill quantity from ap-
prox. 50 ml to approx. 300 ml using the
control knob.
DE
GB
FR
ES
IT
as far
19