Preparing The Appliance For Operation - Gastroback 42606 DESIGN ESPRESSO PLUS Bedienungsanleitung

1. Lift the lid of the water tank upwards. You can lift the water
tank by the open lid (see picture). Rinse the water tank care-
fully. Before first use rinse also filters, portafilter, measuring
spoon and milk jug with warm detergent solution. Follow
the instructions in the section ›Care and Cleaning‹.
2. After cleaning, place the water tank back into the appli-
ance. Make sure that the guide grooves on the back of the
water tank are engaged the cutouts in the back of the appli-
ance. Press the tank down so that the water valve opens in
the bottom of the water tank.
Note:
When pushing down the tank you will see that the valve cover opens upwards.
Before the first use, you should operate the appliance without coffee. The internal
components of the appliance will be heated and purged. Follow the instructions
according to the section ›Preparing a Coffee‹.

PREPARING THE APPLIANCE FOR OPERATION

WARNING: Never leave small children unsupervised with the appliance or the
parts of the appliance! Always make sure that the appliance is properly and fully
assembled and the selector switch is positioned on standby (centre) before plugging
the power cord into the outlet and turning on the appliance.
ATTENTION: If the selector switch is positioned to the right (in
brewing position), after preheating, hot water emerges from the
group head. If the selector switch is positioned to the left (steam/
hot water), hot steam or hot water (depending on the setting)
emerges from the steam wand. Make sure that the black folding
switch is in the correct position: steam or hot water.
Make sure to position the selector switch to the ›Standby‹-postition
(middle) first. Press the ›on/off‹-switch and turn on the appliance.
The power indicator lights red. During preheating the heating indi-
cator lights red. Once the appliance is ready for operation the heating indicator
turns off.
Note:
Always turn the appliance off with the ›on/off‹-switch, unplug the power cord and
wait until the appliance has cooled down before removing/replacing or cleaning
the appliance water tank or drip tray.
Keep the workstation clean and dry. Do not let any liquids run above or below the
ON OFF
49