Closing The Door; Installation - Küppersbusch ITE1260-2 Benutzerinformation

Problem
The compressor does not
start immediately after press-
ing the , or after changing the
temperature.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

Closing the door

1. Clean the door gaskets.

INSTALLATION

WARNING! Refer to Safety
chapters.
Possible cause
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.
Location
Solution
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Make sure that there is cold
air circulation in the appli-
ance.
Refer to the assembly
instructions for the installation.
11