Machine Installation; Preparation For Installation; Electrical Connection; First Use - ECM 82045 Bedienungsanleitung

4

MACHINE INSTALLATION

4.1 Preparation for installation

Place the machine on an even and stable surface.
Never place the machine on hot surfaces.

4.2 Electrical connection

Make sure that the local main supply voltage corresponds to the information given on the type
plate on the front panel of the espresso machine.
Plug the machine into a grounded socket only and do not leave it unattended.
Do not roll or bend the power cord.
Do not use an extension cord/ do not use a multiple socket.
5

FIRST USE

5.1 First use
Read the instruction manual carefully prior to operating the machine.
Prior to starting the machine, check if:
the steam and hot water valves are closed.
the machine is switched off. (Power switch in lower position.)
the power cord is disconnected.
the drip tray is inserted accurately.
Now you can start up your machine:
1 Open the cup warmer tray.
2 Take out the water tank and rinse it thoroughly.
3 Fill the water tank with fresh water low in lime, place it back into the water tank guides and close the cup
warmer tray.
4 Insert the plug into the wall socket. Turn the power switch to "1". The machine is now on.
5 The green control lamp lights up.
6 The pump will fill the boiler of the machine with fresh water.
7 As soon as the boiler is filled, there will be no more pump noise; the orange control lamp is now on. As soon as
the fresh water drops down to a certain level in the fresh water tank, the machine switches off and the light of
the orange control lamp switches off. Now refill fresh water. The machine heats up automatically.
8 Because a large amount of water is required for the first filling of the boiler, the water tank has to be refilled with
fresh water.
9 Wait until the boiler pressure gauge indicates approx. 1.0-1.25 bar.
10 A manual "boiler ventilation" is not necessary because the MECHANIKA V SLIM is equipped with a professional
depression valve that ventilates the boiler during the heating-up phase.
11 Move the group lever into the upper position and dispense approx. 250 ml of water. This way, the heat exchanger
will be filled with water and the circulation of the water in the thermosyphon system begins.
12 Move the group lever into the lower position. Refill the water tank if necessary.
13 The machine is now ready for use. Put the cups on the cup heater tray in order to preheat them and enjoy your
coffee.
User Manual MECHANIKA V SLIM 19
ENGLISH