Startup And Shutdown - online ZINTO E-Serie Benutzerhandbuch

4.5

Startup and shutdown

1. Plug the power cable of the UPS system into an outlet (includ-
ed in the scope of supply of ZINTO E 3000). The display of the
UPS system lights up and shows "StbY."
2. Keep the button
onds.
3. If the display
restart the UPS system, if necessary. (See Troubleshooting.)
4. Make sure that "NORM" is displayed on the display. The UPS
system works in normal mode and supplies the consumers
with power.
Startup in battery mode
To activate the output frequency of 50 or 60Hz, the UPS sys-
tem must be supplied from the power supply and started at
least once before the first use of the battery mode.
1. Keep the button
play lights up.
The UPS system runs through the self-test. The display shows
"bATT." The UPS system supplies the connected consumers
with power.
2. If the display
restart the UPS system, if necessary. (See Troubleshooting.)
ZE1000-3000_manual_ger_eng_it_V1.0.3
on the UPS system pressed for three sec-
lights up, remedy all warning messages and
NOTE
on the UPS system pressed until the dis-
lights up, remedy all warning messages and
59 / 120
........................................................................
O P E R A T I O N
R. Kistler