Programming; Entering Program Mode - Dometic MCS5 Bedienungsanleitung

_BA_MCS.book Seite 15 Donnerstag, 2. April 2009 9:56 09
MCS5, MCS15
To view the service history log proceed as follows:
Turn off the AC power.
Press the Fan Button and hold it.
Turn on the AC power.
Once Power On Reset is completed (display indicates "888" and all LEDs
are lit) release the Fan Button.
The display will flash the most recent fault detected, followed by the event
chronology number.
To view other events detected press either the Up or Down Button.
To clear the service history log simultaneously press the Power and Down
Buttons.
To exit the service history log
– press either the Power, the Up or the Down Buttons or
– wait thirty seconds without pressing any button.
8

Programming

8.1

Entering Program Mode

Press and hold the Power Button while in the Off Mode until the letter "P"
appears in the display.
The characters "P1" followed by the parameter setting, appear in the
display.
The Marine Climate System is now in the Program Mode.
Note
I
The Marine Climate System will exit the Program Mode and return
to the Off Mode if no programming is attempted for one minute.
8.2 Changing Program Parameters
Increment from one program parameter to the next by pressing the Fan
Button.
Press the Up and Down Buttons to select the data or set the desired limits
for the parameter being programmed.
Programming
15