Data Exchange; Polled Mode - SICK DME5000 Betriebsanleitung

Operating Instructions
DME5000
8009813/ZJV1/2017-05
Annex
13.7.3

Data Exchange

The type of data exchange is set in the window "Edit I/O Parameters":
5-byte data are sent, bytes 0 to 3 are the measured value, byte 4 the diagnosis data:
Byte
Position Value (low Byte Attribute 10)
0
Position Value
1
Position Value
2
Position Value (High-Byte-Attribute 10)
3
Laser on: MF1
4
1 active: 1
Laser off: MF1 not
0 active: 0
7 6
Warning:
All pre-failure messages are output as collective message here:
 Overtemperature
 Contamination
 Laser pre-failure message
Alarm:
Plausibility error signals that no measurement is possible; measured value "0" is output at
the same time.
13.7.4

Polled Mode

The process data exchange between DME5000 and DeviceNet-Master is by default
performed by a polled I/O connection. The slaves are cyclically targeted by the master.
© SICK AG • Germany • Subject to change without notice
MF2 Reserved
active: 1 by
DeviceNet
MF2 not
active: 0
5 4, 3, 2
Chapter 13
Warning: 1 Alarm: 1
No No Alarm:
warning: 0 0
1 0
135