Lnb Settings - Megasat HD 1 Kompakt Bedienungsanleitung

4. Instructions for measuring with a mobile device

4.7 LNB settings

In this submenu you can set the reference
parameters for the LNB settings. Swipe left or
right to toggle between the values of each
item.
The default values are set to Universal LNBs
and only need to be adjusted in special ca-
ses. In general, you only need to adjust your
DiSEqC circuit.
SAT: Change the satellite
TP: Changes the respective transponder
LNB Typ: Depending on the LNB type, you
must set the appropriate frequency here. In
general, use „Universal 9750-10600". If you
want to calibrate the system with Unicable,
read the description „Unicable settings" on
the next pages.
22K: Enable or disable the 22K circuit here.
LNB power: Select the desired LNB voltage
(13V, Auto or Off ).
Switch: Select „NONE" if the satellite system
is operated without DiSEqC switch. If you
want to calibrate the system with DiSEqC circuit or Unicable LNBs, read the description
„DiSEqC" or „Unicable" on the following pages.
Port: If you use DiSEqC, you can set the appropriate port here.
Band: Here you can set the respective frequency band if you want to set up a Unicable
system. Please read the description „Unicable Settings" on the following pages.
Position: Select „FIXED" if you want to set a fixed antenna. If you would like to measure
the system with DiSEqC 1.2 or USALS, please read the respective description on the
following pages.
ENGLISH
16