Cleaning The Inspection Window; Cleaning The Surfaces; Maintenance - Wamsler WP2-8K GRAN PELLET Aufstell- Und Bedienungsanleitung

WP2-8_F
Cleaning the burner pan holder
After removing the burner pan, the holder
can be cleaned from deposits.
When the burner pan is installed, pay
attention to its proper position!

8.2. CLEANING THE INSPECTION WINDOW

The appearance of vapour on the inspection window is a normal phenomenon, and does
not indicate any deficiency.
When solid fuels are used, deposition appears on the inspection hole, especially when the ash
of the applied wood pellet is very fine. Depending on the quality of the pellet (especially with
small performance), this deposit can be both light and dark. Clean the glass of the doors of the
combustion chamber with a with cloth, and remove tenacious contaminations with the use of
special detergents to be purchased at the boiler dealership (these detergents do not contain
corrosive acids or solvents jeopardizing glass surfaces).

8.3. CLEANING THE SURFACES

Varnished surfaces may be cleaned only when the varnish has become fully solid, otherwise it
will become scratched. For cleaning, use a wet cloth to wipe the surfaces, without scrubbing it.
Do not use glass cleaners or other, solvent-containing detergents.

8.4. MAINTENANCE

Before the commencement of maintenance, thoroughly clean the burner pan, the burner
pan holder and the combustion chamber.
ALL THE SAFETY REQUIREMENTS DESCRIBED IN SECTION 8 HAVE TO BE OB-
Warning! / Caution!
SERVED!
68 / 192