Discharging/Charging The Pellet Tank - Wamsler WP2-8K GRAN PELLET Aufstell- Und Bedienungsanleitung

WP2-8_GB 59 / 192
X: Current room temperature
Y: Set room temperature
The room temperature can be adjusted with the use of the P5 and P6 buttons.
Return to the main page by repeatedly pressing the P4 button.

5.4. DISCHARGING/CHARGING THE PELLET TANK

The pellet consumption of the fireplace depends on the set performance grade. Check at least once a day whether
its quantity is sufficient.
In case the tank is fully empty "
, then the "NoPellet error message appears on the screen. In this case, use
the P2 button to confirm the message, and fill the tank. Press the P2 button to restart the device.
Warning!
When the device is first started up, or the tank has become fully empty, the re-ignition of the fireplace takes longer,
because in these cases the feeding system should first be fully charged.
It may be necessary to repeat the procedure of starting. In this case, the screen shows the "2." message.
This message warns that the starting procedure has to be repeated by keeping the P2 button pressed longer for
two times.
If the fireplace is not restarted within 15 minutes, the F01 (unsuccessful ignition) error message appears.
IMPORTANT INSTRUCTION!
Before starting, always ensure that the burning pot should be fully empty, meaning that it may not hold even ash or
pellet, because the clogged burning pot leads to malfunctioning.
It is essential to check the burning pot regularly during programmed operation.
These checks are recommended to be performed in the programmed operating breaks.
ENABLING / DISABLING THE "BEEP" AUDIO SIGNAL:
Default setting: "Beep" audio signal OFF.
Enable the audio signal as follows:
The fireplace has to be switched off.
1. On the main screen, keep the P3 button pressed (for 3 seconds).
2. The following message appears on the display: