Valve Clearance Adjustment - Yamaha TTR90 Fahrer- Und Wartungshandbuch

VALVE CLEARANCE ADJUSTMENT

1
3 2
1
4. Check:
• Valve clearance
Out of specification → Adjust.
Valve clearance (cold):
Intake valve:
0.05 ~ 0.09 mm
(0.0020 ~ 0.0035 in)
Exhaust valve:
0.08 ~ 0.12 mm
(0.031 ~ 0.047 in)
Checking steps:
• Turn the crankshaft counterclockwise with
a wrench.
• Align the T.D.C. mark a on the rotor with
the align mark b on the crankcase cover
when piston is at T.D.C. on compression
stroke.
• Measure the valve clearance using a
feeler gauge 1.
Out of specification → Adjust clearance.
5. Adjust:
• Valve clearance
Adjustment steps:
• Loosen the locknut 1.
• Turn the adjuster 3 in or out with the
valve adjusting tool 2 until specified clear-
ance is obtained.
Turning in → Valve clearance is
decreased.
Turning out → Valve clearance is
increased.
Valve adjusting tool:
YM-8035/90890-01311
• Hold the adjuster to prevent it from moving
and tighten the locknut.
• Measure the valve clearance.
• If the clearance is incorrect, repeat above
steps until specified clearance is obtained.
3 - 10
INSP
ADJ
7 Nm (0.7 m · kg, 5.1 ft · lb)