Operating Elements; Before Start-Up; Assembling The Cleaner; Connections - Makita 447 M Betriebsanleitung

2.2

Operating elements

3 Before start-up

3.1

Assembling the cleaner

On delivery some of the accessories
are lying in the tank and must be re-
moved before the vacuum cleaner
is used for the first time.
Remove the upper section of the
vacuum cleaner:
The mains plug should not be in-
serted into a socket.
4 Operation
4.1

Connections

4.1.1 Connecting the suction
hose

4.1.2 Electrical connection

See fold-out page at the front of
these operating instructions.
1 Handle with cable hook
2 Switch with suction power
control
1. Open the retaining clamps
and lift off the upper section
of the cleaner.
2. Take the accessories out of
the dirt tank and the packag-
ing.
The operating voltage shown on the
rating plate must correspond to the
voltage of the mains power supply.
3 Retaining clamp
4 Dirt tank
5 Grip to empty tank
6 Inlet fitting
7 Tool socket
8 Hose diameter setting
3. To pick up dust with maxi-
mum room concentration
values:
Insert the filter bag into the
dirt tank according to the
instructions (instructions in-
cluded).
To pick up harmless dust:
Insert the disposal bag (in-
structions included) into the
tank.
IMPORTANT:
the filter bag connection firm-
ly on to the inlet fitting.
4. Fit the upper section of the
vacuum cleaner and close
the retaining clamps.
NOTE: Ensure that the
retaining clamps fit properly.
1. Connect the suction hose.
The suction hose diameter must
suit the position of the switch in
order to pick up dry, nonflam-
mable dust with maximum room
concentration values.
1. Ensure that the vacuum
cleaner is switched off.
2. Insert the power cord into a
properly installed and fused
socket with an earthing con-
tact.
MAKITA 447 M
english
P r e s s
5