Weller WX 2 Betriebsanleitung Seite 33

WX 2
Fig. 7
Fig. 8
Fig. 9
Fig. 10
6.2 Example 1:
adjusting the temperature
1. Press and hold down the required selection key 6 or 13 for 3 sec.
The display changes over to the set-point temperature
(see Fig. 7).
2. Set the required set-point temperature with the turn-and-click
wheel (7).
3. Confirm the value with the Enter key (8).
4. Exit the parameter menu with key 6.
Note If no entry is made for 10 seconds, the parameter menu is exited
automatically.
6.3 Example 2:
Call up parameter menu and select menu option
1. Press and hold down keys 13 and 1 or 13 and 2 or 6 and 3 or 6
and 4 simultaneously.
While the device is changing over to the parameter menu, the
display shows the following message text (see also Fig. 8):
"Changing over to parameter menu" "Hold down keys".
2. Select menu option with the turn-and-click wheel (7).
The selection is shown with a black background (e.g. "Standby
Temp.", see Fig. 9).
3. Confirm the selection with the Enter key (8).
The display changes over to Selection/Entry mode (see Fig. 10).
4. Make your setting with the turn-and-click wheel (7).
5. Confirm the setting with the Enter key (8).
The setting is made and the parameter menu is displayed.
6. Select a new menu option with the turn-and-click wheel (7) and
set the required value (see steps 3.-5.)
– or –
exit the parameter menu with key 6.
9-20