Before Startup; Water Supply - Kärcher K 6.75 M Bedienungsanleitung

Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your Kärcher dealer for further information.

Before Startup

Mount loose parts delivered with appliance
prior to start-up.
Illustrations on fold-out pag-
es!
Illustration
Tools needed for installation (not supplied)
Illustration
Attach the accessory holder to the de-
vice.
Illustration
Attach the transport handle.
Insert holder for trigger gun.
Illustration
Attach the quick coupling to the water
supply hose.
Illustration
-Attach support leg.
Illustration
Attach expanding rivet to axle.
Insert expanding rivet to axle.
Illustration
First push the transport wheel, and then
the sleeve onto the axle.
Illustration
Insert the axle into the bearings.
Illustration
Always hold against axle when performing
the following steps.
First push the sleeve and then the
transport wheel onto the axle.
Attach expanding rivet to axle.
Insert expanding rivet to axle.
Illustration
Attach the wheel caps.
Illustration
Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
Check the secure connection by pulling
on the high-pressure hose.

Water supply

According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
Kärcher; or, as an alternative, a system
separator as per EN 12729 Type BA.
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the Kärcher water
filter (optional accessory, order no. 4.730-
059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Unwind the garden hose from the hose
drum.
Connect the quick coupling of the water
hose to the water tap.
Drawing in water from open reservoirs
When fitted with the appropriate accesso-
ries, this high-pressure cleaner can draw in
surface water, e.g. from water butts or
ponds (max. suction height 0.5 m).
Illustration
Remove the water inlet hose from the
appliance.
Unscrew suction hose connection cap.
Place cap on water connection and turn
by 90° until it locks into place.
Attach Kärcher suction hose with filter
(Optional accessory, order no. 4.440-
238) to the suction hose connection and
suspend into the rain barrell.
Remove air from appliance before oper-
ation.
Switch on the appliance without mount-
ed spray lance and run it until the water
discharging from the trigger gun is free
of bubbles. Switch off appliance and
connect spray lance.
Note: Fill suction hose with water be-
fore use, this will help ventilate the
pump of air.
17
English