Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before Use
EN
1. Place the Base Station and Connect it to an Electrical Outlet
Place the base station in a location that is as open as possible with a good
Wi-Fi signal. Then insert the power cord into the base station and plug it into the
socket. Remove any objects that are closer than 1.5 m from the front and 5cm
from either side of the base station.
Firmly insert the power
cord upwards until the
I: ON
indicator turns on.
O: OFF
＞5cm
＞1.5m
Note: To prevent water stains from wetting wood floors or carpets, placing
the base station on tile floors or marble floors is recommended.
2. Install the Ramp Extension Plate and the Washboard to
the Base Station
Note: Install the ramp extension plate and the washboard until they click into place.
10
3. Remove the Protections
④
②
①
③
＞
5
cm
4. Install the Side Brush
Side Brush Clip
Note: Install the side brush until it clicks into place.
Before Use
5. Connect the Robot to the Base Station
Press and hold the
button on the robot for 3 seconds to turn it on. Place
the robot onto the base station with the mop assembly facing toward
the washboard. Then you will hear a voice notification when the robot
successfully connects to the base station.
Note:It is recommended to fully charge the robot before its first use. When
the robot cannot be turned on after the battery is depleted, manually connect
the robot with the station to charge it.
6. Add the Cleaning Solution
(1) Remove the dust tank cover and pull out the auto-detergent
compartment.
(2) Open the upper lid of the compartment and add the cleaning solution.
(3) Close the lid of the compartment, put it back into the base station, and
then reinstall the dust tank cover. The cleaning solution will be added
automatically while working.
Note:
· Do not add any liquid other than the o cially-approved cleaning solution
to help prevent malfunction.
· Install the auto-detergent compartment until it clicks into place.
7. Add Water to the Clean Water Tank
Take out the clean water tank from the base station and fill up the tank with
clean water. Then install it back into the base station.
Note: Do not add hot water into the water tank, as this may cause the tank to
become deformed.
EN
11
Werbung
