Beko BSE22120X Gebrauchsanleitung Seite 11

Usingtheinstallation clampssecurethehobby
4.
fittin throygly!be holes onthelower c asin
23
Hob
2 Screw
3 Installation clamp
4 Counter
hen installingthe hob ontoa cabinet,a shelf
i
must be installed in order to separate the
abinet from the hob as illustrated in the above
figure.This is not requiredwhen installingonto
a built-under oven.
For example,if it is possibleto touch the bottom of the
product since it is installedonto a drawer, this section
must be covered with a wooden
min. 15 mm
Rear view connection
Location of the connection holes shown in the
belowfigure areschematic,may vary
dependingon the productmodel. Fixthem
accordingto connectionholeson your product.
4
late.
holes
DANGER:
Makingconnections to differentholesis not a
goodpractce in terms of safetysinceit can
damagethe gas and electricalsystem.
DANGER:
Thereare gas andelectricalcomponents
contained within this hob, therefore when
fittingthe mountingsprings/clampsonlyattach
the suppliedfixingsto the connectionholes
shown in this manual, Failure to observe this
advisemayleadto life and propertysafety
Final check
1. Operatethe product.
2. Check the functions.
Future Transportation
Keepthe product's original carton and transport
the product in it. Followthe instructionson the
carton.Ifyoudo nothavethe original c arton,
pack the product in bubble wrap or thick
cardboard and tape it securely.
Checkthe generalappearance of your product
i
or any damagesthat mighthaveoccurred
duringtransportation,
II/EN