Werbung
Fig.48
58
SEAT
Theseat can be adjusted for operators weight and leg reach to provide
acomfortable position for operating the machine.
1.
ADJUSTMENT FOR OPERATOR WEIGHT (A Fig.48)
The seat is adjustable for operator weights between 50Kgs
(110lbs) and 130Kgs (285lbs).
To Adjust:
The position of the adjusting lever and weight gauge is on
the front of the seat, in the centre below the bellows. By
rotating the lever clockwise the weight capacity is increased
and byrotating the lever anticlockwise the weight capacity is
decreased.
HEIGHT OF SEAT CUSHION ADJUSTMENT (B Fig.49)
The seat has three height positions.
To Adjust:
While sitting on the seat grip both sides of the seat cushion,
by raising your weight off the cushion and pulling the cush
ion upwards at the same time the cushion will locate in the
next highest position. By carrying out the same procedure
on the highest position the seat cushion will return to its
lowest position.
FORE AND AFT ADJUSTMENT (B Fig.48)
To Adjust:
The position of the adjusting lever is on the right hand side of
the seat below the seat cushion. By pulling the lever away
from the seat, the seat can be slid backwards and forwards,
when in the desired position release the lever to locate in one
of the pre set positions.
BACK REST ADJUSTMENT (A Fig.49)
To Adjust:
The position of the release lever is on the left hand side of the
seat. While sitting on the seat pull the release lever upwards
to release the back rest.( The back rest is spring loaded to
fold onto the seat cushion.) Lean back to obtain the desired
position for the back rest and release the lever to locate in
one of the pre set positions.
Werbung
