HUBER+SUHNER MCX Serie Montageanleitung

Assembly instruction
Connector type: 11_MCX-50-1-13
RG_178_B/U, RG_196_A/U, G_01132-06
Suitable cables:
Parts list connector:
Assembly steps:
Picture
The cable assembly of R.F. connectors can only be done by well trained assembly staff and suitable assembly equipment.
Huber+Suhner's skilled staff and specialised equipment are available to carry out complete R.F. lead-assembly on your behalf.
We mount your connectors on cables at economic prices! Please contact our representative for further details of this service.
Series MCX
In case of cable G_01132-06
is used, do not use ferrule B
and insert the cable into the
connector without this ferrule.
Process
Slide ferrule A onto cable.
Prepare cable according to
diagram.
Splay out braid and slide
ferrule B over dielectric of
cable.
Push contact C over inner
conductor of cable and crimp.
Insert cable in body D.
Slide ferrule A over braid and
crimp.
0000180181
Old instruction No. 27316
Inner conductor contact:
Outer conductor contact:
Feature / Check
Do not damage braid,
dielectric and inner
conductor of cable.
Contact C as close as
possible to dielectric of
cable.
Ensure the braid lies
above the crimp neck.
Ferrule A as close as
possible to body D.
Deutscher Text: siehe Rückseite
Crimped (Cavity 1)
Crimped (Cavity A)
Tools required
Suitable stripping tool
Crimp tool : Cavity 1
For large crimp tool and
table press use insert
76_Z-0-2-1
Crimp tool : Cavity A
For large crimp tool and
table press use insert
76_Z-0-2-1
Revision C
Date 03.08.2021
Initiator 4186 / MAP