HUBER+SUHNER 11_N-50-7-69 Montageanleitung

Assembly instruction Series N
11_N-50-7-69
Connector type:
S_07162_B, LMR 400
Suitable cables:
Parts list connector:
A
Assembly steps:
Picture
B
B
B
D
B D
A
X
The cable assembly of R.F. connectors can only be done by well trained assembly stuff and suitable assembly equipment.
Huber+Suhner's skilled stuff and specialised equipment are available to carry out complete R.F. lead-assembly on your behalf.
We mount your connectors on cables at economic prices! Please contact our representative for further details of this service.
B
Process
Slide shrink tube A and
ferrule B onto cable.
Prepare cable according
to diagram.
Length of foil prepares
same as braid.
C
Push contact C over
inner conductor of cable
directly to the dielectric
and crimp.
Splay out braid and
insert cable in connector
body D until stop.
Slide ferrule B over
braid and crimp.
D
Slide shrink tube A over
ferrule B, body D and
shrink.
0000311731
Inner conductor contact:
Outer conductor contact:
C
D
Feature / Check
Do not damage braid,
dielectric and inner
conductor of cable
Contact C flush to
dielectric.
Ensure that braid lies
above the crimp neck.
Foil must be pushed in
bore hole.
Crimp as close to
connector body D as
possible.
Shrink tube A as close
as possible to edge X.
Deutscher Text: siehe Rückseite
Crimped(Cavity 4)
Crimped(Cavity D)
Tools required
Stanley blade
Scissors
Crimp tool : Cavity 4
For large crimp tool and
table press use insert
76_Z-0-7-14.
Crimp tool: Cavity D
For large crimp tool and
table press use insert
76_Z-0-7-14.
Hot-air fan
Revision A
Date 28.04.09
Initiator 46819/MZhu