Silvercrest SAS 100 A1 Bedienungs- Und Sicherheitshinweise Seite 14

After cutting: Pull the slicing carriage
backwards . Repeat the process until the
desired number of slices has been cut .
˜ Troubleshooting
Problem Cause
The power
plug
15 ] [
connected to a
power outlet .
The product
is not
functioning .
6 ] [
pressed .
˜ Cleaning and care
DANGER! Risk of electric shock!
Before cleaning or maintaining the product:
Disconnect the power plug
power outlet .
DANGER! Risk of electric shock!
Do not immerse the product in water or other
liquids . Never hold the product under running
water .
CAUTION! Risk of injury!
m
The circular blade
hold the circular blade
surface but instead by the blade lock
m CAUTION! Risk of injury!
The circular blade
the product if it is not properly installed .
Lock the mechanism into place correctly
during assembly (blade lock
horizontal!) .
14 GB
10 ] [
Solution
Connect the
is not power plug
[ 15 ]
to a power
outlet .
Press and hold
.
[ 6 ]
Press and hold
is not
until
[ 5 ]
the circular
blade starts
4 ] [
up .
from the
[ 15 ]
is very sharp . Never
[ 4 ]
by the cutting
4 ] [
.
3 ] [
can fall out of
[ 4 ]
must be
[ 3 ]
˜ Cleaning (after each use)
NOTE: Do not use any abrasive, aggressive
cleaners to clean the product .
Cleaning the circular blade
NOTES:
Clean the circular blade
with warm soapy water .
The circular blade
4 ] [
Fold the slicing carriage
the right and out of the joint .
E
Turn the blade lock
it vertically . Remove the circular blade
(Fig . E) .
After cleaning: Allow the circular blade
to dry .
after every use
4 ] [
is not dishwasher safe .
up and pull it to
10 ] [
[ 3 ]
[ 4 ]
clockwise and align
3 ] [
4 ] [
4 ] [