Shark WV270EU Serie Bedienungsanleitung Seite 21

MAINTAINING YOUR VACUUM
CLEANING THE FILTER
1. With the dust cup removed and the power off,
pinch both sides of the filter housing and pivot
it upward to access the filter.
NOTE: Do not wash any parts or accessories in a dishwasher.
40
s h a r kc l e a n . e u
1
2. Hold the filter housing over a bin. Lift the fabric
filter by the metal ring to remove it from the
housing. Tap lightly to remove any dust and
debris, then rinse with water only. Let the filter
air-dry for at least 24 hours or until completely
dry before reinstalling.
WARNING: To reduce the risk of shock and unintended operation, turn off
2
power and remove the battery before servicing.
Vacuum is not picking up debris. No suction or light suction. Power button blinks white six times, in
2-second intervals.
• Check filters to see if they need cleaning. Follow instructions for rinsing and completely air-drying the
filters before reinstalling them.
Vacuum turns off on its own.
There are several possible reasons for the vacuum turning off on its own, including blockages, battery
issues, and overheating. If vacuum turns off on its own, perform the following steps:
1. Turn on the power and check the battery indicator lights on the vacuum. If recharging is needed, make
sure vacuum power is off before charging.
2. Empty dust cup and clean filters (See the Cleaning the Dust Cup and Filter section).
3. Check accessories and inlet openings and remove any blockages.
4. Allow unit and battery to cool for at least 45 minutes, until they return to room temperature.
5. Press the On/Off button to restart the vacuum.
POWER BUTTON
Vacuum shuts off. Power button
blinks 5 times in 2-second
intervals, then stops.
Boost mode button is blinking.
Boost mode button blinks 5 times
in 2-second intervals, then stops.
NOTE: If vacuum still does not operate properly, contact Customer Service at 0800 862 0453 or Sharkclean.eu.
MAINTAINING YOUR VACUUM
TROUBLESHOOTING
WHAT IT MEANS WHAT TO DO
With the power off, check the nozzle
opening for blockages. Remove any
obstructions. Allow unit and battery to
cool for at least 45 minutes, returning
Low voltage start. to room temperature. The battery may
need to be charged. Charge completely
(approximately 3.5 hours) by placing the
vacuum on the charging stand. If problem
persists, contact Customer Service.
Allow the vacuum cleaner and battery to
cool to room temperature for about 45
minutes. While waiting, refer to the cleaning
Motor is overheating. section and remove any blockages. These
can impede airflow. The unit can be placed
on the charger and will start charging when
it has reached normal temperature.
With the power off, check the nozzle
opening for jams or clogs. Remove any
Overspeed.
obstructions. If the problem persists, contact
Customer Service
41
s h a r kc l e a n . e u