Shark WV270EU Serie Bedienungsanleitung Seite 19

CHARGING WHILE IN STORAGE
Charge the unit by sliding it into the charging base
nozzle-first.
REMOVING THE BATTERY
BATTERY
NOTE: When docked properly, the charging lights on the hand vacuum will fade, indicating that charging has begun.
When charging is complete, the power button will dim, then shut off.
NOTE: The main unit comes with a partial charge. For maximum runtime, charge fully before first use (approximately
3 hours). Leaving the unit plugged in will not damage battery life.
36
s h a r kc l e a n . e u
CHARGING
BASE CONTACTS VACUUM CONTACTS
Make sure the contacts on the wand are aligned
with the contacts on the charging post.
When charging is complete and you need to use
the unit again, lift it off the dock plate.
To remove the battery from the hand vacuum,
press the release tabs on the battery cap and slide
out the battery. To reinstall, slide the battery
into the compartment in the handle until it clicks
into place.
USING YOUR VACUUM
POWER
Press the On/Off button on the handle to turn on
power. To turn off power, press the button again.
USING YOUR VACUUM
USING ACCESSORIES
To attach an accessory to the hand vacuum, slide
it into the opening in the nozzle. To remove the
accessory, slide it off the nozzle.
CONTROLS
BOOST MODE
For an added boost of power, press the Boost
button. Press again to return to normal power.
s h a r kc l e a n . e u
37