Stiga TCX 122 Gebrauchsanweisung Seite 74

– T he device cannot be used when driving in
reverse.
– W hen the device is on, the pedal (4.32) can-
not be put into reverse («R»).
NOTE Speed may vary from that set when go-
ing up or down hill.
To turn off the device and reset pedal speed
control (4.32) just:
– p ress the drive pedal (4.32) in the «F» direc-
tion (forward gear);
or
– press the brake pedal (4.31).
In both cases the mushroom-head button auto-
matically returns to position «A».
IMPORTANT Always avoid pressing the
mushroom-head button to turn off the device.
4.13 GRASS CATCHER TIPPING
CONTROL (Fig. 4.1 no 13)
Manual control
The grass catcher may be tipped to empty
by pulling the lever (13.1), whichcan be ex-
tracted from its housing.
Electric control
The grass catcher may beemptied by
pressing the push-button (13.2), keeping it
pressed untilthe control motor stops.
The grass catcher returns to the working
position by pressing thepush-button (13.3),
keeping it presseduntil the pawl hooks into
place and thecontrol motor stops.
4.31 BRAKE PEDAL (Fig. 4.2 no.31)
This pedal works the brake on the rear wheels.
4.32 CLUTCH PEDAL (Fig. 4.2 no.32)
This pedal engages drive in the wheels and con-
trols the machine's forward and reverse speed.
– T o engage forward gear just press it in the «F»
direction with the tip of your foot, noting that
increasing the pressure on the pedal progres-
sively increases the speed of the machine.
– R everse is engaged by pressing the pedal
with the heel towards «R».
– T he pedal automatically goes into neutral «N»
when released.
– T he "neutral" condition «N» is shown bythe
lighting of a pilot lamp (4.7.e).
All manuals and user guides at all-guides.com
when the machine has stopped.
forwards or for reverse, when the parking brake
(4.5) is engaged, the engine stops.
This lever has two positions as shown on the
label:
«A» = T ransmission engaged: for all uses,
«B» = T ransmission disengaged: this makes
mission unit, this operation must be carried out
only when the engine has stopped with the pedal
(4.32) at position «N».
instructions (see 5.5) if the equipment will
mainly be used on sloping land (never over
10 degrees.
the positions of controls are those described in
chapter 4.
The safety devices work in two ways:
– t hey prevent the engine from starting if all the
– b y stopping the engine if even just one of the
a) To start the engine, it is necessary that:
– t he transmission is in "neutral";
– a ll the cutting means are disengaged;
– t he operator is seated;
b) The engine stops when:
– t he operator leaves his seat;
– the grass catcher is lifted or the rear dis-
– t he parking brake is engaged without disen-
10
WARNING! Reverse must be engaged
NOTE If the drive pedal is used, whether
4.33 HYDROSTATIC TRANSMISSION
DISENGAGEMENT LEVER
(Fig. 4.2 no.33)
when moving and during cutting;
it much easier to move the machine by
hand, with the engine turned off.
IMPORTANT To avoid damaging the trans-
5. OPERATING INSTRUCTIONS
5.1 SAFETY
RECOMMENDATIONS
WARNING! Read the safety operating
IMPORTANT All the references relating to
5.2 WHY THE SAFETY DEVICES CUT IN
safety requirements have not been met;
safety requirements is lacking.
charge guard removed without disengaging
the cutting means;
gaging the cutting means;