Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.2 Removing and cleaning the metal grease filter
Removing the metal grease filter
• To access the filter on the front,
grasp the front flap at its lower edge
and fold it upwards.
Then proceed as follows to remove each filter part:
• Pull back the pusher of the filter so that the lock releases.
• Tilt the filter slightly out of the holder opening
and secure it with your second hand
so that it cannot fall down and cause damage.
• Remove the filter from the appliance.
Cleaning the metal grease filter
Clean the multipart metal grease filter every 2-3 weeks,
depending on the frequency of use of the cooker hood,
as described in the following sections,
repeating the process if necessary.
ATTENTION!
Risk of damage!
To avoid damaging the filter, do not use any sharp or pointed
cleaning utensils or aggressive or acidic cleaning agents!
Avoid alkaline cleaning agents (pH value above 7)!
Make sure you use a sufficient but appropriate amount
of cleaning agent so that the grease can dissolve!
If the amount of cleaning agent is not sufficient,
the grease will saponify, which means that the filter can only
be degreased with aggressive special cleaning agents
or must be replaced!
Metaldiscolourationduetocleaning
Frequent cleaning, especially in the dishwasher,
or the use of aggressive cleaning agents can cause changes
in the colour of the metal surface.
These have no influence on the function of the metal
components and are not grounds for complaint.
Cleaning and Maintenance
2-3 w.
33
Werbung
