Set the temperature
CAUTION
The standard temperature is 23 °C. Setting the temperature can only be done
using the remote control.
1.
Press the PLUS and MINUS buttons to set the desired temperature, from 10 °C to 35 °C.
2.
Press the OK button to confirm.
3.
The display will show the set temperature.
If you have set the temperature, the device will select the power required to reach the set
temperature. Once the device has reached the set temperature, the heating element will
switch off but the ventilator will remain switched on for another 5 minutes. The heating
element will switch on again if the ambient temperature reaches a temperature of 2 °C below
the set temperature.
Turn off the thermostat
1.
Press the function button to set heating on low or high power.
2.
The display will show '- -'.
3.
The device will continuously heat on low or high power for 12 hours.
4.
After 12 hours the device will stop heating.
5.
The device will cool down for 5 minutes.
6.
The device will go in standby mode.
Open window detection mode
Open window detection mode can only be activated with the remote control.
1.
Press the OPEN WINDOW button on the remote control.
2.
The open window detection mode indicator switches on.
3.
When the ambient temperature decreases 5 °C or more within 10 minutes, the device
will go in standby mode.
4.
Press the OPEN WINDOW button to deactivate.
Set the week timer
CAUTION
Your settings will be lost if the unit is switched off using the main switch, if
there has been a power cut or if the plug has been removed from the socket.
Press "SET" to check the day and time and set them again if necessary.
1.
Press the PROGRAM button ('P').
2.
The program indicator will appear on the display.
3.
Press the DAY button to select the desired day, from d1 (Monday) to d7 (Sunday).
4.
Confirm with the EDIT button. The display will show P1.
5.
Use the EDIT button (Figure 6, pos. 9) to select the desired program, from P1 to P6.
•
A maximum of six programs can be set per day.
6.
Confirm with the TIME ON button (Figure 6, pos. 10). The display will show '00'.
7.
Use the TIME ON button to set the start time, from 0 to 23.
28