bürkert 8623-2 Betriebsanleitung Seite 74

6.6.5 "AMPL" - Setting the amplification K
è Select the amplification factor K
(factory setting: 1,00). If an attempt is made to enter a higher value, the
display will jump automatically to 0 and a value within the range must be
entered.
Setting assistance:
• If unacceptably high overswings occur after set-point step with the set
value for K
• On the other hand, a unsatisfactory regulation dynamism can be improved
by increasing K
Operating Instructions No. 803 052
p
, or if the regulation is unstable, you must reduce K
p
as long as the above-mentioned instability does not arise.
p
2 s
p
in a range from 0,00 to 10,00 ‰ / Hz.
Increase the position
Next position
Set decimal point
.
p
73