Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Installation should be carried out by a suitable qualified person and any repairs should be
carried out by an authorised service agent. No supply cord is fitted one some Cl ovens. The
terminal block in the Cl oven is designed to allow different types of connections as shown
on the information label located next to it.
HOB INSTALLATION
1. Place the silicone strips (supplied) around the hole in the worktop (fig. 1). The dimensions of
the hole are given in the booklet supplied with the hob.
2. Fix the hob into its housing so that its edges come in contact with the silicone strips (fig. 2).
3. Utilise the fixing brackets you will find inside the package (fig. 3).
OVEN INSTALLATION AND ITS CONNECTION TO THE ELECTRIC OR CERAMIC HOB
4. After having installed the hob, connect it to the oven in this way: firstly place the oven next to its
housing.
5. Remove the steel terminal block cover (A) (fig. 4). You will then see one connector:
— (G) is for the connection to the domestic power supply
CONNECTION TO THE TERMINAL BLOCK (fig. 5)
6. — Pass the cable throught the hole (B).
— Strip the insulation away from the end of each cable and connect them to the terminals (G),
remembering that the earth cable (yellow-green) must
10 mm longer than the other wires. Use only rubber insulated cable, type H05RR-F.
— Make sure that the screws have been tightened.
— Do not forget the earth wire.
— Fix the cable clamp and refit the protection (A).
— Reassemble the terminal block cover (A).
7. Connect the 2 connectors block of the hob with the oven as shown in fig. 6.
8. Insert the oven into its housing completely and fix it to the furniture by means of the four screws
supplied in the package.
CONNECTION TO THE ELECTRICITY SUPPLY
The appliance must be connected to a 30 amp supply with a suitable overload protection device. A
double pole circuit breaker must be used with a contact gap of at least 3 mm in both poles. Before
carrying out this work, check the earth system of the power supply. The earthing of the appliance is
obligatory by law. The manufacturer declines all responsibility damage to persons or objects cau-
sed by any failure to observe these norms.
Warning: connection to the mains power supply should only be made after connecting up
the terminals and having replaced the relevant covers
18
FIG. 1
INSTALLATION TABLE FOR OVEN-HOB COMBINATIONS
Hob
Total power/consumption: oven + hob (kW)
power/
Hob
consump-
type
tion
(kW)
PES 64
6,3
PVS 604
6,2
GB
GB
FIG. 2
FIG. 3
FIG. 6
FIG. 5
dimension/section
V ~
FLC20
FLC60
V2 ~
8,4
8,4
3x4mm
2
8,3
3x4mm
8,3
2,
19
FIG. 4
Supply cable
V2N ~
V3N ~
V3 ~
4x2,5mm
5x2,5mm
2
2
4x2,5mm
5x2,5mm
2
2
Werbung
