Silvercrest SDR 1100 B2 Bedienungsanleitung Seite 31

If there is no more water in the water tank
steam lever is pressed
♦ Remove the plug from the mains power socket .
♦ Wait about 10 seconds .
♦ Slowly open the safety valve
a few seconds until the hissing of the water vapour stops .
♦ Fill the water tank
♦ Reclose the safety valve
If the mains water at your locality is rated as hard, it is recommended that you
mix the mains water with distilled water . Otherwise, the appliance could calcify
prematurely and clog the steam nozzle
To extend the optimal functioning of the appliance, mix the mains water with
distilled water as per the following table .
The water hardness level of your tap water can be queried at your local water
works .
■ 28 │ GB │ IE
. The water tank must be filled as follows:
with water .
3
.
8
Water hardness
very soft/soft
medium
hard
very hard
3 , no steam will come out when the
. Before fully opening up the valve, wait
8
.
6
Ratio of distilled water
to mains water
0
1:1
2:1
3:1
SDR 1100 B2