Werbung
、
Ø6*40(2 pcs）
ST4.2*30(2 pcs）
M4*6(2 pcs）
Power connection
•
Do not connect the unit to the mains until it has been properly installed.
•
Never install the appliance if the information on the rating plate (V) does not
match your mains voltage. The rating plate is located inside the appliance,
behind the grease filter.
•
If the cooker bonnet is equipped with a standard plug, connect it to an easily
accessible standard socket.
•
If the appliance is not equipped with a connection plug, a two-pole, standard-
compliant switch with a contact gap of 3 mm must be installed by an
authorised specialist in an easily accessible place.
•
When the cooker bonnet is connected to the mains, all indicator lights light up
briefly and the cooker bonnet switches to standby mode (accompanied by a
beep).
Installation with exhaust air (fume cupboard outside):
Note: Failure to fit the screws or fixing device in accordance with these
instructions may result in electrical hazards.
Note: Observe the safety instructions for operating the unit when the air is
discharged to the outside. If the cooker hood is in operation at the same time
as an appliance that draws its energy from a source other than electricity, the
negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar).
Chimney Mounting
Bracket
Decorative
Chimney
Top
Ø6*40(2 pcs）
(2
EN
37
Werbung
