-
During the adjustment of the fl oat switch
(5), ensure that the fl oat switch does
not contact the fl oor before the pump
switches off.
There is a risk of dry running if
the fl oat switch cable (7) is set too
long, especially if the fl oat switch
height adjustment (6) is not fi tted
(see "Start up").
Manual mode/fl at
suction
Caution: Avoid dry running
of the pump! Danger of over-
heating!
Never touch an overheated
pump! There is a danger of
burns!
In manual mode, the pump does not switch
off automatically, as the fl oat switch (5) is
bypassed.
The fl oat switch (5) must be positioned ver-
tically upwards on the pump for this.
Slide the fl oat switch height adjustment (6)
over the fl oat switch guide (8) next to the
handle (1).
Pull the fl oat switch cable (7) through the
fl oat switch height adjustment (6), until
the fl oat switch (5) is positioned vertically
above the height adjustment (6). See illus-
tration
.
Monitor the pump constantly when
in manual mode. Switch the pump
off immediately (disconnect from the mains)
if no more water is being pumped. There is
a risk of damage if the pump runs dry.
Maintenance and
Cleaning
Clean and maintain your equipment regu-
larly. This will guarantee its performance
and long durability.
Ask our service centre to car-
ry out any work that is not
described in these instruc-
tions. Use only original parts.
There is a risk of injury!
Pull out the power plug before
every maintenance operation. There
is a risk of electrocution or of injury
from moving parts.
General cleaning
instructions
•
In case of transport for utilization in
different locations, the pump must be
cleaned with clear water after every use.
•
In case of stationary installation, the
function of the fl oat switch (5) is to be
checked regularly (at the latest every
three months).
•
With a water jet, remove fl uff and
fi brous particles which are possibly
present in the pump casing (3).
•
Clean precipitation from the fl oat
switch (5) with clear water.
•
Regularly remove sludge from the pit
base (at the latest every 3 months) and
also clean the shaft walls.
•
Dirt on the bottom of the pump can be
washed down with clear water.
Any measures above and beyond these,
particularly opening the equipment, are
to be carried out by an electrician. In the
case of repairs, always contact our service
centre.
GB
MT
25