hajdu HB200C Handbuch Über Inbetriebnahme, Bedienung Und Wartung Seite 68

_________________________________ ___EN__________________________________20
heating to run over several heating cycles, press the E-heater button once
again.
6.6. How the Appliance Operates
When the appliance is switched off, press the
power up. Using the
38 and 60℃), press the
automatically heat up the water in the tank to the desired temperature.
6.7. Function buttons
E-heater
This mode can be set manually. If the E-heater is disabled, follow the steps below
to enable it.
 Press the 'E-HEATER' button; the icon '
 Press the 'ENTER' button to confirm that you want to activate electrical heating
in the appliance. With the assistance of the electrical heating, you can already
achieve the desired higher water temperature.
 Then, if necessary, re-activate the "E-heater" and repeat the steps.
 If E-heater is not active any more, pressing 'E-HEATER' again will make the
icon ' ' reappear on screen.
Switching between temperature units
 Press and hold down the 'E-HEATER' button for 10 seconds, then select the
desired temperature display format. You can switch from 'F' to 'C' or from 'C'
to 'F', in order to display the temperature in Celsius or Fahrenheit degrees
respectively.
 Default value: 'C'.
INCREASE/UP &
When the keylock is released, you can 'INCREASE' or 'DECREASE' the
selected value by pressing these keys.
 When setting the temperature, you can continuously increase (decrease) the
temperature value by continuously pressing the 'DOWN' ('UP') button for 1
second.
 When setting the clock/timer, you can continuously increase (decrease) the
buttons set the desired water temperature (between
button gombot, and the appliance will
' displays on the screen.
DECREASE/DOWN
button. The appliance will