Silvercrest SSPM 6 A2 Bedienungsanleitung Und Sicherheitshinweise Seite 10

SilverCrest SSPM 6 A2
5. Copyright
All the contents of this user manual are protected by copyright and provided to the reader for
information only. Copying data and information without the prior explicit written consent of the
author is strictly forbidden. This also applies to any commercial use of the contents and information.
All texts and diagrams are up-to-date as of the date of printing. Subject to change without notice.
6. Before you start
Remove the SSPM 6 A2 mill and all accessories from the packaging and check that the package
contents are complete. Keep the packaging material away from children and dispose of
appropriately.
7. Getting started
7.1 Inserting the batteries/filling the mill

Hold the container (6) firmly and turn the top section (1) anti-clockwise until the arrow on the
top section (1) is lined up with the

Remove the top section (1) from the container (6).

Remove the motor (3) from the container (6).

Insert the batteries with the correct polarity (note + and -). The correct polarity is labelled on the
batteries and inside the battery compartment.

Fill the container (6) with peppercorns or coarse salt. Fill the container (6) up no higher then the
padlock symbols

Place the motor (3) onto the container (6). Make sure that the contacts (4) of the motor (3) are
aligned properly with contacts (5) on the container (6).

Place the top section (1) onto the container (6).

Hold the container (6) firmly and turn the top section (1) clockwise until the arrow on the top
section (1) is lined up with the
7.2 Using the mill

Remove the protective cap (7) on the bottom of the container (6).

Keep the button (2) pressed to switch on the mill. The light (8) lights up when the device is in
use.

Replace the protective cap (7) onto the bottom of the container (6) after use.
7.3 Changing the grind setting

Remove the protective cap (7) on the bottom of the container (6).

Turn the adjusting screw (9) slightly anti-clockwise for a coarser grind setting.

Turn the adjusting screw (9) slightly clockwise for a finer grind setting.

Replace the protective cap (7) onto the bottom of the container (6).
8 - English
symbol on the container (6).
and .
symbol on the container (6).