LIVARNO home KL-11870 Gebrauchsanweisung Seite 5

• The light source for this lighting fixture is not re-
placeable; when the light source has reached
the end of its service life, the entire lighting
fixture must be replaced.
• Make sure the solar cell does not get dirty or
covered in snow or ice in winter. This reduces
the performance of the solar cell.
• Note that cold temperatures have a negative
impact on battery life.
Risk of injury!
• Ensure that when the light is removed, the
ground peg is also removed, so that it does
not pose a danger (e.g. tripping).
Warnings regarding the
storage battery!
• Only charge intact and undamaged storage
batteries.
• Protect the storage battery from mechanical
damage. Fire risk!
• If electrolyte solution leaks from the storage
battery or the product then avoid contact with
your eyes, mucous membranes, or skin. Rinse
the affected areas immediately with plenty of
clear water and consult a doctor. The electro-
lyte solution can cause irritation.
• Never charge or store the storage battery in
the vicinity of large heat sources or open fire as
this could cause the storage battery to explode.
• The charging contacts on the storage battery
may not be connected using metal objects.
• Never try to manipulate, modify, or repair a
storage battery or the product.
Danger!
• The storage battery may not be thrown into
the fire or short-circuited after removal. The
storage battery could overheat and explode.
• Do not dismantle the storage battery.
Assembling the product
1. Remove the individual parts from the packaging
and assemble the product according to Figure B.
You have two options here: with the spacer
tube (3), the product will be approx. 39cm
high (Fig. D), and approx. 51cm high with the
spacer tube (2) (Fig. C).
2. Insert the chosen spacer tube (2) or (3) into
the recess on the solar module (5) (Fig. B).
3. Finally, insert the ground peg (1) into the un-
derside of the spacer tube (2) or (3) (Fig. B).
Setting up the product
Note: the product can be set up independently
of a power source.
• Only use the product with the ground peg (1)
supplied.
• Insert the assembled product far enough into
the ground (lawn, flower bed) to ensure its
stability. As the product depends on solar
energy, you must remember and observe the
following points before setting it up:
1. Select a spot where the solar module (5) is
exposed to sunlight throughout the day.
2. Position the product so that the solar
module (5) does not become covered or
shaded (trees, leaves, etc.).
3. Ensure the solar module (5) is not influenced
by other light sources, such as garden or street
lighting, otherwise the product will not switch
on at dusk. Remember that many light sources
are dependent on time and movement and
only come on in the middle of the night.
Before using the product for
the first time
Note: the product has a twilight sensor and an
on/off switch (5d).
• Unscrew the ball (4) anticlockwise from the
solar module (5). Before using it for the first
time, slide the on/off switch (5d) to ‚ON'.
• Screw the ball (4) clockwise back onto the
solar module (5) until it stops and place the
product in the sun.
Switching the product on/off
• Slide the on/off switch (5d) to ‚ON'. The
product automatically switches on at dusk.
• With KL-11870, there is an automatic colour
change from red to green to blue.
Note: push the button (5f) once to stop it on
the required colour. Push the (5f) button again
to reactivate the colour sequence.
GB 5