Intended Use; Warranty; Transport And Storage; Identifying The Product - Hürner WeldControl 800-O Bedienungsanleitung

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
• The machine must be operated only when in proper state of repair
and for one of the intended uses. Before welding, the welder is
required to make sure that the state of the machine is in order.
During transport, the facing tool and the heating element
have to be placed into the provided carrying rack at all
Important
times.
2.5

Intended Use

The Butt-Welding Machine is intended exclusively for joining plastic
pipes and fittings according to the butt-welding process with heating
element. See Section 3 for a detailed overview of the welding process
enabled by this machine.
The notion of intended use also includes:
• Compliance with the instructions in the User's Manual
• Observation of all service and maintenance intervals
All uses other than those mentioned above are not allowed
and will cancel any and all liability or warranty by the manu-
facturer. Unintended use may cause considerable hazards and
Important
material damage.
2.6

Warranty

Warranty claims may be raised only if the conditions for warranty given
in the General Terms and Conditions of Sale and Delivery obtain.
2.7

Transport and Storage

When the product is transported or stored, the hydraulic tubing
should not be detached or squeezed. For transporting the pipe
facing tool and the heating element, use the provided carrying rack
at all times.
2.8

Identifying the Product

Every product is identified by a name plate. It shows the model ("Typ"),
the serial number ("Maschinennr."), and the manufacturer. The first
two digits of the serial number represent the year of manufacture.
3

Understanding the Machine

This butt-welding machine for plastics can be used both as an on-site
and as a workshop installation, for jointing operations pipe-to-pipe,
but also for processing tees and elbows (see also the first paragraphs of
Sect. 4.3 and 4.4 for more detailed information on this). The machine
enables welding according to two modes, the Manual Mode and the
Data Logging/Report Generation mode, or SPG Mode for short.
In the manual mode, the machine performs a classic, manual butt-
welding operation. It monitors the temperature of the heating ele-
ment, taking the desired nominal temperature into account, and
readjusts it as needed.
In the SPG mode, the machine guides the welder through the welding
process, monitors all relevant parameters, and allows entering trace-
ability data for the welded components on intuitive menu screens.
Parameters of the welding operation, component traceability data,
and possible errors are recorded and saved to memory and can be
transferred via one of two USB interface ports to a USB stick, a USB-
Version May 2011 HÜRNER WeldControl 800-O User's Manual
Stumpfschweißmaschine
Typ 800 WeldControl
Maschinennr. 11010821
Hürner Schweisstechnik
Nieder-Ohmener Str.
D - 35325 Mücke
CE
Tel. +49 6401 9127 0
9
EN